2. Adhere to cleaning the machine and timely adjust and tighten the loose parts to prevent the wear of parts or the loss of parts due to the looseness.

3、注意冷再生機磨合期的工作負荷，磨合期內的工作負荷一般不能超過額定工作負荷的80%，并要安排合適的工作量，防止設備因?yàn)殚L時間持續作業而出現過熱。

3. Pay attention to the working load during the running-in period of the cold regenerator. The working load during the running-in period shall not exceed 80% of the rated working load, and appropriate workload shall be arranged to prevent the equipment from overheating due to long-term continuous operation.

4、磨合期停止，應對設備進行一次保養，同時注意油液的更換。

4. When the running-in period is stopped, the equipment should be maintained once and the oil should be replaced.

5、注意經常檢查潤滑油、液壓油、冷卻液、制動液以及燃油（水）位，并注意做好整機密封性的檢查，檢查中如果發現油水缺乏過多，應查明原因，同時，應做好各潤滑點的潤滑強化，建議在磨合期內，每次使用前都要進行潤滑油的檢查與添加。

5. Pay attention to check the lubricating oil, hydraulic oil, cooling fluid, brake fluid and fuel (water) level frequently, and pay attention to check the sealing of the whole machine. If there is too much oil and water in the inspection, find out the reason. At the same time, strengthen the lubrication of each lubricating point. It is recommended to check and add the lubricating oil before each use during the running-in period.

冷再生機在磨合期內使用保養的要求可歸納為：減輕負荷、注意檢查、強化潤滑。只要做到上述幾點，就可以減少早期故障的發生，提高運行的與穩定性，延長設備的使用壽命。更多相關內容就來我們網站http://www.wlc189.com咨詢吧！

The requirements for the use and maintenance of the cold regenerator during the running-in period can be summarized as follows: reduce the load, pay attention to inspection and strengthen lubrication. As long as the above points are achieved, the occurrence of early failures can be reduced, the safety and stability of operation can be improved, and the service life of the equipment can be extended. Come to our website for more relevant content http://www.wlc189.com Ask!