對于任何設備來說，想要保證設備的正常運行，是需要進行養護工作的，冷再生設備也同樣如此，不過該設備的養護有搶修與維修兩種情況，這兩種狀態有什么區別呢？下面冷再生機租賃公司為您講下。

For any equipment, maintenance is required to ensure its normal operation, as is the case for cold regeneration equipment. However, the maintenance of this equipment can be divided into emergency repair and maintenance. What is the difference between these two states? Now let's talk about it for you.

冷再生機施工時會產生均勻的較厚鋪層內，不存在傳統施工方法中出現的較薄鋪層間的薄弱界面。因其具備、等優點而受到廣大用戶的喜愛，同時也可以改善施工條件，減輕經濟壓力，是許多小型施工單位的選擇。

The cold recycling machine will produce a uniform thick layer during construction, and there is no weak interface between thin layers in traditional construction methods. Because of its environmental protection, energy conservation and other advantages, it is loved by the majority of users. It can also improve the construction conditions and reduce economic pressure. It is the choice of many small construction units.

維修的主要目的在于盡可能使設備保持良好的運行狀態，一旦有工作需要就可以立即進入工作的狀態。而且維修也是有既定的流程要求的，主要可以分為診斷、定位、隔離、修復校正等幾個步驟，而且都需要有一定技能的維修人員來完成?？偟膩碚f，維修其實更側重于是在工作間隙、在設備不工作的時候進行的。

The main purpose of maintenance is to keep the equipment in good operating condition as far as possible, and it can enter into working condition immediately once there is a need for work. Moreover, maintenance also has established process requirements, which can be mainly divided into several steps, such as diagnosis, positioning, isolation, repair and correction, and all of them require maintenance personnel with certain skills to complete. In general, maintenance is more focused on the work gap and when the equipment is not working.

而如果遇到了比較緊急的情況，再按照平時維修的標準和程序進行修復的話，就會花費很多的時間，會嚴重影響到施工的進度和工期，同時也會降低冷再生機的利用率，這時候我們就需要進行設備搶修工作，以達到讓設備快速恢復工作狀態，保證工程進度的目的。

In case of an emergency, it will take a lot of time to repair according to the normal maintenance standards and procedures, which will seriously affect the construction progress and duration, and will also reduce the utilization rate of the cold regenerator. At this time, we need to carry out equipment repair work to quickly restore the equipment to its working state and ensure the project progress.

此外每天作業后應該瀝青設備內的殘余水泥混凝土，使拌刀磨損減小，延長了拌刀使用壽命;整機所有器件的塵土，對潤滑部位加注黃油，使整機潤滑部件的潤滑情況良好，減小了易損件的磨損，從而減少了因磨損而出現的機械故障。

In addition, the residual cement concrete in the asphalt equipment shall be removed after daily operation, so as to reduce the wear of the mixing knife and prolong the service life of the mixing knife; Remove the dust from all components of the whole machine, and add grease to the lubricating parts to ensure good lubrication of the lubricating parts of the whole machine, reduce the wear of wearing parts, and thus reduce the mechanical failure caused by wear.

檢查各緊固件及易損件，發現問題及時予以解決，使有些故障排除在未出現以前，做到防患于未然;能堅持每班保養，瀝青設備使用壽命平均可延長工作時間800h，拌刀可延長600h。

Check all fasteners and wearing parts, and solve problems found in time, so that some faults can be eliminated before they occur, so as to prevent problems before they occur; The maintenance can be carried out every shift. The service life of asphalt equipment can be extended by 800h on average, and the mixing knife can be extended by 600h.

以上是對于冷再生機的維修與搶修區別的簡單介紹，希望可以對您有所幫助。我公司是的道路施工設備生產廠家，在設備銷售的同時還提供設備的租賃服務，如果您有相關需要的話，可以致電我公司http://www.wlc189.com進行咨詢。

The above is a brief introduction to the difference between the repair and emergency repair of the cold regenerator. I hope it can help you. Our company is a professional manufacturer of road construction equipment. We also provide equipment leasing services while selling equipment. If you have any related needs, you can call our company http://www.wlc189.com Consult.